Mitutoyo Dial Indicator Tip 513 402

In recent times, mitutoyo dial indicator tip 513 402 has become increasingly relevant in various contexts. Case neck thickness measurements - Long Range Hunting Forum. I also use a ball micrometer to measure neck wall thickness and a good (Starrett or Mitutoyo) micrometer for all other dimensions for the accuracy of my measurements. Short action customs modular sizing dies - Long Range Hunting Forum. Mitutoyo digital calipers, a digital mic, and a digital ball mic.

In relation to this, once you have all those and are comfortable with them, then you'll be able to get the correct SAC shoulder inserts. How To Get Consistent Seating Depth Every Time from an empirical source .... From Mitutoyo's website: "Caliper Accuracy The measurement accuracy of the caliper, sometimes termed instrumental error, may be expressed in steps. The first step for the 0-200 mm (0-8 inch) range shows a measurement uncertainty of ±0,02 mm (±.000 8 inch) over this range (when set to zero with the jaws closed) which increases by around ±0,01 mm (±.000 4 inch) for each ... Primer crush…does it matter?

- Long Range Hunting Forum. For the same reason I have a AMP, V-4 System, Henderson Trimmer, Whidden Dies, NECO Concentricity, Redding Instant Indicator, JGS Reamers, Mitutoyo Measuring, ect. I want to be able to get CONSISTANT results for each and every cartridge I reload and rifle I shoot. I don't just reload to push a bullet through a rifled barrel.

My Lapua 300 prc brass experience...... Yes I used a 324 then 314 bushing. In relation to this, loaded od on lapua is 3165 and adg 3145 with my mitutoyo outside micrometer.

Your lot of ADG must be thicker than mine. When I necked down the ADG, I used a 324 bushing, then ran into a FL 7saum non bushing die. The FL die may have flowed some the brass into the shoulder.

Short Action Customs Sizing & Seating Dies - Evaluation & Discussion. Average runout on these fired cases measured .0015. (one and a half thousandths) All of the measurements other than the neck were a very low variance, to the point where neither my mitutoyo caliper or micrometer could measure the difference.

Setting the die up to begin sizing operations was a breeze! Neck Tension vs Bullet Seating & Release Pressure - Lessons Learned. EQUIPMENT & MATERIALS: K&M Arbor Press with standard force pack and Mitutoyo dial indicator (0.001" ~ 1 lb of force; max = 150 lbs) K&M hollow die base LE Wilson Case Holder (H&H Magnum size) to hold cartridge body concentrically to and in-line with the press ram movement Bullet cold weld to brass, real or myth? I have been reading over the last 18-20 months about a phenomenon where the bullets for lack of a better description "cold welds" to the brass.

I've seen a few articles by well known long range competitors, David Tubb chief among them claiming that bullets especially ones left loaded for... Building on this, dial indicator help - Long Range Hunting Forum. Did Mitutoyo make a model 513-504 with .0001" accuracy/graduation using an extra long tip/contact point?